FAQs

To program your garage door opener remote, first locate the 'Learn' button on the motor unit. This button is typically purple, red-orange, green, yellow, or white. For wall-mounted jackshaft openers, you'll need to lift the access door on the motor to find the 'Learn' button. Press and release this button. Within 30 seconds, press and hold the remote button for approximately two seconds. This action will program that specific button to the motor. The next time you press the remote button, it will operate the door. For additional remotes, simply repeat these steps.

To program your garage door keypad, begin by locating the 'Learn' button on the motor unit. It's usually purple, red-orange, green, yellow, or white. For wall-mounted jackshaft openers, you'll need to lift the access door on the motor to access the 'Learn' button. Once located, press a 4-digit code of your choice into the keypad within 30 seconds. Immediately after, press and hold the 'Enter' button for a couple of seconds. This process programs the new 4-digit code to that specific motor and erases any previously programmed codes for that door.

To erase all programmed devices from your garage door opener, press and hold the 'Learn' button for approximately 8 seconds. You'll know the process is complete when the LED light next to the button turns off. This action will erase all remotes and keypads associated with that motor. After erasing, you'll need to reprogram your devices following the instructions provided for programming remotes and keypads.